Frispel

sedan 2001

Slam tilt

Gator

  • Jr. Member
  • **
    • Antal inlägg: 85
    • Visa profil
  • Stad: Sävedalen
Vad har jag för fel på mitt TOM när slam tilten aktiveras och spelet slocknar under normalt spel, utan åverkan från min sida. Romen är bytt men det gjorde ingen skillnad.
//Ingemar
AC/DC LTBR, AFM, BtDK, CC, CV, CftBL, FH, LotR LE, MM, MB, SS, TAH LE, TotAN, TOM, TZ.


CKR

  • Donator Silver
  • Hero Member
  • *****
    • Antal inlägg: 1018
  • www.flippercenter.se
    • Visa profil
  • Stad: Torslanda
Undrar om du inte råkat ut för detta:

Wacky Switch Matrix due to Low 12 volts.On some WPC games, in particular Theatre of Magic, a weak BR1 or weak 7812 voltage regulator on the power driver board can cause some wacky switch matrix problems. For example, if the game is doing a "slam tilt" or randomly firing the slingshots or flippers or other coils, the power to the switch matrix may be weak. The 12 volt fluctuation for the switch matrix can often be seen when many of the feature lamps are on. Try removing connector J133 (disabling the playfield controlled lamps) and see if the problem goes away. If it does, rebuild the 12/18 volt power secition (BR1, C6, C7, the Q2 7812 voltage regulator), and install jumper wires from BR1 to its associated filter caps (as described in the reset section). This bridge rectifier and voltage regulator supply the power for the switch matrix. For example, wacky game behavior on Theatre of Magic (ToM) can be caused by low or intermittent 12 volt power (usually due to a bad or cracked traces around bridge BR1). Maybe most all coils fire like slingshots, magnets, pop bumpers, and the low (hold) voltage on flippers, or even a slam tilt.
www.flippercenter.se
flippercenter@gmail.com


P Q

  • Donator Silver
  • Hero Member
  • *****
    • Antal inlägg: 2137
    • Visa profil
  • Stad: Lomma

JPM

  • Hero Member
  • *****
    • Antal inlägg: 524
  • veni vidi vomui
    • Visa profil
  • Stad: Skepplanda
Jag har med lite problem med slam tilt på mitt SS.
har inte hunnit att kolla upp det än men är nyfiken på olika versioner på vad det kan vara.

Jag startar spelet och den går in i slamtilt med en gång, känns som glapp, sen står det closed slamtilt switch, men swicharna är hela.. nåt på nåt kort?

:O


CKR

  • Donator Silver
  • Hero Member
  • *****
    • Antal inlägg: 1018
  • www.flippercenter.se
    • Visa profil
  • Stad: Torslanda
JPM:

I ditt fall är det väl något åt det här hållet:

Slam Tilt Stuck Closed Error.
Upon turning the game on, a "slam tilt stuck closed" error is shown, and the game just won't do anything past that. This can be as simple as the slam switch inside the coin door is bent closed. Also there is a slam switch in the bottom of the cabinet to the left of the coin box (be sure to check that switch too). Or it could be some sort of CPU switch problem. To issolate the problem, turn the game off and disconnect all the connectors from the bottom of the CPU board. Then turn the game back on. If the error is no longer shown, the problem is in the playfield or cabinet wiring/switches. If the error is still shown, the problem is in the CPU board itself. If the problem is on the CPU board, usually it's a problem with a ULN2803 or LM339 chip.
www.flippercenter.se
flippercenter@gmail.com


Gator

  • Jr. Member
  • **
    • Antal inlägg: 85
    • Visa profil
  • Stad: Sävedalen
Tack för alla snabba tips. Det jag har kollat coindoor kontakten som är ok. Hade jag ett nytt driver kort från Pinled liggandes som jag monterade.

Resultatet är att det fungerar nu.

Kommer att felsöka på det gamla driverkortet och återkommer med vad som var fel.
AC/DC LTBR, AFM, BtDK, CC, CV, CftBL, FH, LotR LE, MM, MB, SS, TAH LE, TotAN, TOM, TZ.


JPM

  • Hero Member
  • *****
    • Antal inlägg: 524
  • veni vidi vomui
    • Visa profil
  • Stad: Skepplanda
PUH!!!
Efter att jag felsökt igenom och mätt upp switchar och gått igenom CPU-kort bytt ut ULN2803 och kollat upp LM339 utan resultat så känndes det jobbigt.
Slam Tilt Stuck Closed Error stod hånande i DMD´n
När jag kollade i switchmatrisen och inte hittade något där blev jag irriterad och drämmde till sidan av kabbet och svor lite...då lät det som en switch gör när man testar dom...det visade sig till slut att det hade trillat ner en skruv från något och kilat in sig imellan kretskortet och kabbet det kretskort som sitter till vänster nere i kabinettet när man öppnar myntluckan, skruven låg och kortslöt slamtilten på baksidan.



=)